Service The Electronics; Service The Cover; Perform Final Tests - Magtek ExpressCard 2000 Hardware Service Manual

4 - Preventive Maintenance Procedure (EC3000)

4.13 Service the Electronics

Visually inspect all wires and cables, checking for insulation breakage or wear on moving cables.

4.14 Service the Cover

After completing all other service, service the cover as follows:
1) Inspect the cover for damage.
2) Clean the black and gray portions of the outside of the cover with alcohol wipes.
3) Clean fingerprints off the touchscreen with a soft, clean, dry cloth.

4.15 Perform Final Tests

After completing preventive maintenance, follow these steps to test the device and restore it to its original
state:
1) Re-connect the power and network cables.
2) Re-attach any security hardware.
3) Re-install consumables.
4) Close all open doors.
5) Power on the device.
6) Re-synchronize the image printer ribbon, if necessary (some printer models do not require this step).
7) Create a sample card using customer card stock.
8) Check image print quality and embosser alignment, and adjust components as necessary using the
information in section 6 Adjustments.
9) Fill out the checklist included with the preventive maintenance kit, and return it to MagTek.
Ensure any unused materials from the kit are personally handed off to a branch
representative – most importantly, any used or unused print ribbons or embossing foils.
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 74 of 356 (D99875607-91)