Service The Exit Transport Module; Cool The Tipper Heater / Power Down The Device - Magtek ExpressCard 2000 Hardware Service Manual

3 - Preventive Maintenance Procedure (EC2000)
3.8

Service the Exit Transport Module

No additional service is necessary for the Exit Transport, other than the roller cleaning described in
section 3.3 Clean All Transport Rollers.
3.9

Cool the Tipper Heater / Power Down the Device

The tipper heater operates at temperatures that are not safe to touch. Be sure to cool
down the tipper heater to a safe working temperature before working on or near it.
1) On the touchscreen, navigate to
2) Press the
Set Heater OFF
3) Note the value under
tipper heater is not safe to touch.
4) Take note of the current time, and plan your work to allow enough time for the tipper heater to cool,
which can take up to 15 minutes. You may be able to use compressed air to cool it more quickly.
5) Power down the device.
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
>
Menu Settings
button to turn off the tipper heater.
. If the tipper temperature is 50°C or hotter, the
Current Tipper Temp
Page 50 of 356 (D99875607-91)
> to open the
Tipper Tipper
page.