Magtek ExpressCard 2000 Hardware Service Manual page 39

3 - Preventive Maintenance Procedure (EC2000)
3) On the touchscreen, navigate to
Controller Commands
4) Use the white cleaning card and do not let the rollers take it out of your hand as you clean each set
of rollers as follows:
a) Feed the cleaning card partly into the hopper shuttle and press the
the card there until the rollers stop moving.
Figure 3-1 - Cleaning the Hopper shuttle Rollers (TOP VIEW FROM FRONT)
b) Feed the cleaning card partly into the left side of the exit transport and press the
button. Hold the card there until the rollers stop moving.
Figure 3-2 - Cleaning the Left Side of the Exit Transport (TOP VIEW FROM FRONT)
c) Feed the cleaning card partly into the right side of the exit transport and press the
button. Push inward to keep the card from being pushed out until the rollers stop moving.
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
>
Menu Settings
page.
Page 39 of 356 (D99875607-91)
> >
Service MCP Cmds
Roll To Printer
to open the
button. Hold
Exit Eject
Exit Reject