Magtek ExpressCard 2000 Hardware Service Manual page 152

5 - Removal and Re-installation
8) Plug the flex cable into the hopper shuttle so it points toward the rear of the device as shown.
9) Remove the backing from the foam tape.
10) Gently pull the long loop of the flex cable straight toward the rear of the device, away from the
hopper shuttle. This puts the flex cable in the right position to stick it to the motor.
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 152 of 356 (D99875607-91)