Magtek ExpressCard 2000 Hardware Service Manual page 240

5 - Removal and Re-installation
14) Rotate the embosser wheel so the empty tines are facing the exit transport and tipper and leave it in
that position through the end of re-installing. This reduces the chances of damaging critical tines.
15) Find the multi-connector panel in the top deck plate, to the left of the exit transport.
16) Find the exit transport module's cable connected to the rear right corner plug, and the embosser
module's connector connected to the front left corner plug (Figure 5-101).
17) Use a slotted screwdriver or equivalent to pry the sides of the exit transport connector out of the plug,
then gently disconnect it. Avoid pulling directly on the wires.
Figure 5-101 - Exit Transport and Cables (TOP VIEW FROM FRONT)
18) If you are replacing the exit transport in an ExpressCard 3000, disconnect the foil sensor (Figure
5-102):
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 240 of 356 (D99875607-91)