Magtek ExpressCard 2000 Hardware Service Manual page 241

5 - Removal and Re-installation
a) For easier access, you may disconnect the embosser cable then re-connect it after re-installing.
b) Find the foil sensor on the top front of the exit transport.
c) Follow its cable down the front left corner of the module to a cable clip on the top deck.
d) Unclip the cable and follow it further to the connector.
e) Disconnect the cable.
Figure 5-102 - Foil Sensor Cable (TOP VIEW FROM FRONT)
19) Disconnect the exit transport magnetic stripe reader (MSR) cable as follows:
a) On the left side of the exit transport, find the connector between the cable and the MSR head and
disconnect it. Carefully note which connector you are disconnecting the cable from.
b) Pull the exit transport slightly forward (or out) and cut the cable tie that holds the MSR cable to
the main cable on the bottom back of the exit transport's base.
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 241 of 356 (D99875607-91)