Table of Contents
Advertisement
ASDA-A3
Connecting multiple servo drives:
(1) Connection to the controller / motion control card
(2) DMCNET terminal resistor. This is produced by Delta PLC department; please contact your
local distributors for ordering information.
Note:
1.
This supports up to 12 axes and the cable length of up to 30 m.
2.
It is suggested that you use a terminal resistor of 150 Ω (Ohm) and 0.5 W (or more).
3.
To connect multiple servo drives in serial, please use DMCNET connectors as shown above, and put
the terminal resistor in the last servo drive.
Revision December, 2017
Wiring
3
3-49
- Quick Links:
- Asda-A3 Series Servo Drive
- Wiring
- Alarm List
Hide quick links:
Advertisement
Table of Contents
