Delta ASDA-A3 Series User Manual page 321

Parameters
When these parameters are modified, please re-start the servo drive to ensure it functions normally.
Use P3.006 to change the source for the digital signal, either through an external terminal block or
communication parameter P4.007.
8
P2.011
Default:
Unit:
Format:
Settings:
Please refer to the description of P2.010.
P2.012
Default:
Unit:
Format:
Settings:
Please refer to the description of P2.010.
P2.013
Default:
Unit:
Format:
Settings:
Please refer to the description of P2.010.
P2.014
Default:
Unit:
Format:
Settings:
Please refer to the description of P2.010.
8-64
DI2 functional planning
0x0104
-
HEX
DI3 functional planning
0x0116
-
HEX
DI4 functional planning
0x0117
-
HEX
DI5 functional planning
0x0102
-
HEX
Control mode: All
Setting range: 0 – 0x015F (last two codes are
DI codes)
Data size: 16-bit
Control mode: All
Setting range: 0 – 0x015F (last two codes are
DI codes)
Data size: 16-bit
Control mode: All
0 – 0x015F (last two codes are
Setting range:
DI codes)
Data size: 16-bit
Control mode: All
0 – 0x015F (last two codes are
Setting range:
DI codes)
Data size: 16-bit
ASDA-A3
Address: 0216H
0217H
Address: 0218H
0219H
Address: 021AH
021BH
Address: 021CH
021DH
Revision December, 2017