Delta ASDA-A3 Series User Manual page 345

Parameters
X
0
8
1
2
3
4
5
6 – 8
9
A
B
C
D
Y: masking pulse adjusting lead

Bit
8 – 15
8-88
Actual
Function master
axis pulse
Function
Receive
disabled
actual
Stops
master
operation
axis pulse
Continuous
forward
running
Continuous
reverse
Masked
running
Forward
JOG
Reverse
JOG
- -
Pulse
masking of
master
axis
Continuous
forward
Receive
running
actual
Continuous
master
reverse
axis pulse
running
Forward
JOG
Reverse
JOG
Function
Function
0 Virtual pulse number is not written to P5.087 (initial lead).
disabled
Write the
Write the virtual pulse number to P5.087 (initial lead).
1
lead
2
Set the virtual pulse number to P5.087 (initial lead) and write this
Write to
value to EEPROM.
ROM
3
4
Write the virtual pulse number plus the pulse number of one cycle
Plus one
(P5.084 / P5.083) to P5.087 (initial lead).
cycle
5
Plus one Write the virtual pulse number plus the pulse number of one cycle
6
cycle and (P5.084 / P5.083) to P5.087 (initial lead). Then write this value to
7
write to ROM EEPROM.
Reserved -
Virtual
pulse
E-Cam is driven by the actual master axis pulse.
N/A
E-Cam stops operating, but the masked master
pulse continues to be stored in the internal variable.
The source of the E-Cam master axis is the virtual
pulse frequency in kpps, set by P2.077.UZ. This
Virtual
function continues to operate. To stop it, set X to 1.
pulse
function
enabled
The source of the E-Cam master axis is the virtual
pulse number in pulses, set by P2.077.UZ. It only
refers to the pulse number set by UZ during JOG
operation.
- Reserved
E-Cam is driven by the actual master pulse and the
N/A
pulse record is stored in the internal variables.
The source of the E-Cam master axis is the
frequency transmitted by the actual master axis
(P5.088 Y) plus the virtual pulse frequency in kpps,
set by P2.077.UZ. This function continues to
Virtual
operate. To stop it, set X to 9.
pulse
function
The source of the E-Cam master axis is the pulse
enabled
transmitted by the actual master axis (P5.088 Y)
plus the virtual pulse number in pulses, set by
P2.077.UZ. This function is often used during
JOG operation.
Description
Description
Revision December, 2017
ASDA-A3