Delta ASDA-A3 Series User Manual page 320

ASDA-A3
P2.008■
Default: 0
Unit:
-
Format: DEC
Settings:
Special parameter write-in function:
Code
10
20
22
30, 35
406
400
Note: A3-L does not support the E-Cam function.
P2.009
Default: 2
Unit: ms
Format: DEC
Settings:
When environmental interference is high, increasing this value can enhance the control stability.
If you set the value too high, it impacts the response time.
P2.010
Default: 0x0101
Unit: -
Format: HEX
Settings:
U Z YX
YX: input function selection

Please refer to Table 8.1
Z: input contact: A or B contact

0: set this input contact to be normally closed (B contact)
1: set this input contact to be normally open (A contact)
U: not in use

Revision December, 2017
Special parameter write-in function
Reset parameter (power back on after reset).
P4.010 is writable.
P4.011 – P4.021 are writable.
Save Compare, Capture, and E-Cam data.
Enable forced DO mode.
When forced DO mode is enabled, switch back to the normal DO mode.
DI response filter time
DI1 functional planning
Control mode: All
Setting range: 0 – 65535
Data size: 16-bit
Function
Control mode: All
Setting range: 0 – 20
Data size: 16-bit
Control mode: All
0 – 0x015F (last two codes are
Setting range:
DI codes)
Data size: 16-bit
Parameters
Address: 0210H
0211H
Address: 0212H
0213H
Address: 0214H
0215H
8-63
8