Table 23 Error Code C3: 2000-Sheet Feeder Carriage Not In Position Message Troubleshooting Procedure - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RAP 3 Error Code C3-2E: Tray 2 Failure
Error Code C3-3E: Tray 3 Failure
The 2000-Sheet Feeder Tray Assembly has not been set.
Table 23 Error Code C3: 2000-Sheet Feeder Carriage Not In Position Message
Troubleshooting Procedure
Step Actions and Questions
1 PROCEDURE
Open and close the 2000-Sheet Feeder Tray Assembly.
Does the Insert Tray 2/3 message still appear?
2 STOPPER LINK
1. Open the 2000-Sheet Feeder Tray Assembly.
2. Manually push the actuator of the Stopper Link
[RRP 12.17,
3. Make certain the front side of the Nudger Support
Assembly lowers each time you press the Stopper
Link.
Does the Nudger Support Assembly lower each
time you press the Stopper Link?
3 STOPPER LINK
1. Enter Diagnostics mode.
2. From the Main Menu, select Component Test / Sensor
Input / press [4] to start, [0] to stop.
3. Manually push the actuator of the Stopper Link
[RRP 12.17,
Does the LCD counter increment each time you
press the Stopper Link?
"NO" FROM STEP 3 ABOVE
4
1. Switch printer power OFF.
2. Open the 2000-Sheet Feeder Tray Assembly.
3. Remove the Lower Rear Cover.
4. Disconnect P/J603 form the 2000-Sheet Feeder
Board.
5. Switch printer power ON.
6. Measure the voltage between P/J603-3 and frame
ground.
Does the voltage measure +3.2 VDC?
"NO" FROM STEP 4 ABOVE
5
Measure the voltage between P601-1 and frame
ground.
Does the voltage measure +3.2 VDC?
46
page 369].
page 369].
Power Off / On
Power Off / On
Yes
Go to
Step 2.
Go to
Step 3.
Replace the
Print Engine
Controller
Board
[RRP 8.5,
page
Go to
Step 7.
Replace the
2000-Sheet
Feeder
Board
[RRP 12.8,
page
Phaser 5400 Laser Printer Service Guide
No
Problem
solved.
Replace the
Stopper Link
[RRP 12.17,
page 369].
Go to
Step 4.
310].
Go to
Step 5.
Go to
Step 6.
360].