Figure 11-49 Separate Tilt Leg From Leg Support - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
11 - 72
Table 11-3 ADA-L Unit Switch Settings (Continued)
Switch
Dip
Switches
(DSW)
Do not connect T1 and T2 when DSW switches 3 and 4 are On.
12.3.2 Installing the ADA-L UNIT
Perform the following steps to connect the ADA-L UNIT to the
Bottom Option Interface located underneath the DTL/ITL multiline
terminal.
Only one ADA-L UNIT can be installed at a time.
1. Unplug the line cord from the keyset.
2. Turn the DTL/ITL multiline terminal upside down.
3. Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg
Tilt Leg
Output Hook Signal to External Device
DSW 1 On = Output
Off = No Output (Default)
Record Confirmation Tone
DSW 2 On = Tone On
Off = Tone Off (Default)
DSW 3 Use T1/T2
and On = Disable (Default)
DSW 4 Off = Enable
To prevent possible damage to the ADA-L
UNIT or the DTL/ITL multiline terminal
during installation or removal, disconnect
the line cord/LAN cable and the AC/DC
adapter from the DTL/ITL multiline terminal.
Support).

Figure 11-49 Separate Tilt Leg from Leg Support

Installing SV8100/SV8300 Optional Equipment
UNIVERGE SV8100/SV8300
Description/Settings
Figure 11-49
Stoppers