1-16-01 Port Speed Selection - 10/100 Base-T - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
1-16-01 Port Speed Selection – 10/100 Base-T
General Description
When Memory Block 1-16-00 (Auto Negotiation Yes/No Selection) is set to NO, use
this Memory Block to specify the Ethernet port speed as 10 Mbps or 100 Mbps for
each port of each HUB(8)-U( ) ETU.
R1500 or higher is required.
Display
D a t a H U B
N o . 1 ~ 3
0 1 : 1 - 1
T I M E
Settings
LK 1 LK 2
10 100
Programming Procedures
1 Go off-line.
J J K A
2 Press LK1 + LK16 +
3 Press the corresponding CO/PBX line key to change the Setting Data option.
G
4 Press to write the data.
5 Repeat steps 3 and 4 for each port.
E
6 Press to go back on-line.
___________________________________________________________________________________
Programming Manual
S e t t i n g
P O R T
T i t l e
D a t a
1 ~ 8
S P E E D 1 0 0
D I S P L A Y
LK 3 LK 4 LK 5
t o access the Memory Block.
LK 6 LK 7 LK 8
Document Revision 4
System Mode
1
Submode
16
Data No.
01
PC Programming
+AB
The shaded
selection is the
default.
2 - 381