Firmware Update Via Update Server - Auerswald COMpact 5200 Advanced Information

Firmware Update via Update Server

Firmware Update via Update Server
Proceed as follows:
Using the Configuration Manager (page Administration >
•
Firmwareupdate/restart)
• To restore firmware, to restart and (only COMmander 6000/R/RX) to
power down the PBX: By clicking a button on the PBX
Adresse du serveur de mise à jour
Address of the update server that consists of four blocks with three digits
for IPv4 addresses or eight blocks with four digits or characters for IPv6
addresses.
Note: The factory settings are already configured with the address of
the update server (www.auerswald-update.de).
Update
Requirements:
• PBX connected to broadband Internet access
• Configured address of the update server
• Configured DNS server and, if necessary, an HTTP proxy server (page
Administration > Configuration IP)
Configured gateway (page Administration > Configuration IP)
•
When an instant firmware update is enabled via the update server, the
firmware update is initiated automatically. A connection to the update
server is set up and then the server sends the latest firmware to the PBX.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 1141 -