Ip Black And Whitelist - Auerswald COMpact 5200 Advanced Information

IP Black and Whitelist

IP Black and Whitelist
Proceed as follows:
Using the Configuration Manager (page (Seite Administration > Liste
•
des adresses IP bloquées et autorisées)
Activer la liste des adresses IP bloquées
If traffic from a particular IP address is evaluated as being too high - and
therefore probably malicious- this IP address is blocked. This means that
accesses from this IP address to the PBX are initially prevented for one
minute (single block by block time). The administrator is informed about
the block (Surveillance > Status report). During the block time the PBX
continues to monitor the traffic from this IP address. If the traffic from this
IP address to the PBX continues to be too high, the single block time is
extended (block time restarts).
If the number of attacks from IP addresses over the Internet exceeds a
threshold, all traffic outside of the local network is blocked (global block).
The local network is the network configured for the CPU (Administration
> Configuration IP under Configuration Ethernet).
The administrator must then put in place appropriate measures to protect
the PBX within its infrastructure (e.g. using routers or bridges).
Note: The global block deletes all further entries (single blocks) from
the blacklist.
Note: When you open the page it first shows the status, which is
automatically updated every 30 seconds.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 1205 -