Running Configuration Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to back up and restore configuration and firmware.
76.1 Switch Configuration File
When you configure the Switch using either the CLI (Command Line Interface) or web configurator, the
settings are saved as a series of commands in a configuration file on the Switch called running-
config. You can perform the following with a configuration file:
• Back up Switch configuration once the Switch is set up to work in your network.
• Restore a previously-saved Switch configuration.
• Use the same configuration file to set all switches (of the same model) in your network to the same
settings.
You may also edit a configuration file using a text editor. Make sure you use valid commands.
Note: The Switch rejects configuration files with invalid or incomplete commands.
76.2 Command Summary
The following table describes user-input values available in multiple commands for this feature.
Table 181 running-config User-input Values
COMMAND
attribute
Running Configuration
DESCRIPTION
Possible values: active, name, speed-duplex, bpdu-control, flow-control,
intrusion-lock, vlan1q, vlan1q-member, bandwidth-limit, vlan-stacking,
port-security, broadcast-storm-control, mirroring, port-access-
authenticator, queuing-method, igmp-filtering, spanning-tree, mrstp,
protocol-based-vlan, port-based-vlan, mac-authentication, trtcm,
ethernet-oam, loopguard, arp-inspection, dhcp-snooping.
Ethernet Switch CLI Reference Guide
C
H A P T E R
Commands
287
76