ZyXEL Communications XS3800-28 Cli Reference Manual page 125

Table 88 IGMP Command Summary (continued)
COMMAND
ip igmp robustness-variable <2-255>
ip igmp query-interval <1-65535>
ip igmp query-max-response-time <1-
25>
ip igmp last-member-query-interval
<1-25>
no ip igmp
show ip igmp group
show ip igmp interface
show ip igmp multicast
show ip igmp timer
show router igmp
Table 89 IPMC Command Summary
COMMAND
interface port-channel <port-list>
ipmc egress-untag-vlan <vlan-id>
no ipmc egress-untag-vlan
34.3 Command Examples
This example configures IGMP on the Switch with the following settings:
• Sets the Switch to flood unknown multicast frames.
• Sets the Switch to non-querier mode.
• Configures the IP interface 172.16.1.1 with subnet mask 255.255.255.0 to route IGMP version 3 packets.
sysname(config)# router igmp
sysname(config-igmp)# non-querier
sysname(config-igmp)# unknown-multicast-frame flooding
sysname(config-igmp)# exit
sysname(config)# interface route-domain 172.16.1.1/24
sysname(config-if)# ip igmp v3
Chapter 34 IGMP and Multicasting Commands
Ethernet Switch CLI Reference Guide
125
DESCRIPTION
Sets the IGMP robustness variable on the Switch.
This variable specifies how susceptible the
subnet is to lost packets.
Sets the IGMP query interval on the Switch. This
variable specifies the amount of time in seconds
between general query messages sent by the
router.
Sets the maximum time that the router waits for
a response to a general query message.
Sets the amount of time in seconds that the
router waits for a response to a group specific
query message.
Disables IP IGMP in this routing domain.
DIsplays the multicast groups learned by IGMP.
Displays the IGMP status information per
interface.
Displays the multicast traffic information.
Displays the IGMP timer settings.
Displays global IGMP settings.
DESCRIPTION
Enters config-interface mode for the specified
port(s).
Sets the Switch to remove the VLAN tag from IP
multicast packets belonging to the specified
VLAN before transmission on this port.
Enter a VLAN group ID in this field. Enter 0 to set
the Switch not to remove any VLAN tags from
the packets.
Disables the ports from removing the VLAN tags
from outgoing IP multicast packets.
M P
C 13
C 13
C 13
C 13
C 13
E 3
E 3
E 3
E 3
E 3
M P
C 13
C 13
C 13