ZyXEL Communications XS3800-28 Cli Reference Manual page 177

Chapter 43 Layer 2 Protocol Tunnel (L2PT) Commands
This example enables L2PT for STP, CDP and VTP packets on port 3. It also sets L2PT mode to access for
this port.
sysname(config)# interface port-channel 3
sysname(config-interface)# l2protocol-tunnel
sysname(config-interface)# l2protocol-tunnel mode access
sysname(config-interface)# exit
sysname(config)# exit
This example sets L2PT mode to tunnel for port 4.
sysname(config)# interface port-channel 4
sysname(config-interface)# l2protocol-tunnel mode tunnel
sysname(config-interface)# exit
sysname(config)# exit
This example displays L2PT settings and status on port 3. You can also see how many CDP, STP, VTP,
LACP, PAgP and UDLD packets received on this port are encapsulated, decapsulated or dropped.
sysname# show l2protocol-tunnel interface port-channel 3
Status : Running
Layer 2 Protocol Tunneling: Enable
Destination MAC Address: 00:10:23:45:67:8e
Port Protocol State
---- -------- ------
3 cdp Enable
stp Enable
vtp Enable
lacp Disable
pagp Disable
udld Disable
sysname#
Encapsulation Decapsulation
Counter
------------- -------------
0
1280
0
0
0
0
Ethernet Switch CLI Reference Guide
177
Drop
Counter Counter
-------
0 0
2548 0
0 0
0 0
0 0
0 0