ZyXEL Communications XS3800-28 Cli Reference Manual page 278

Table 177 rip Command Summary (continued)
COMMAND
distance <10-255>
exit
ipv6 router rip
distance <10-255>
exit
timer garbage-collection <1-
65535>
timer timeout <1-65535>
timer update <1-65535>
no router rip
interface route-domain <ip-address>/
<mask-bits>
Chapter 74 RIP Commands
DESCRIPTION
When two different routing protocols, such as RIP
and OSPF provide multiple routes to the same
destination, the Switch can use the administrative
distance of the route source to determine which
routing protocol to use and add the route to the
routing table.
Sets the administrative distance (from 10 to 255)
that is assigned to the routes learned by RIP.
The lower the administrative distance value is, the
more preferable the routing protocol is. If two
routes have the same administrative distance
value, the Switch uses the route that has the lowest
metric value.
Note: You cannot set two routing protocols to
Leaves the RIP configuration mode.
Enables and enters the IPv6 RIP configuration mode
on the Switch.
When two different routing protocols, such as RIP
and OSPF provide multiple routes to the same
destination, the Switch can use the administrative
distance of the route source to determine which
routing protocol to use and add the route to the
routing table.
Sets the administrative distance (from 10 to 255)
that is assigned to the routes learned by RIP.
The lower the administrative distance value is, the
more preferable the routing protocol is. If two
routes have the same administrative distance
value, the Switch uses the route that has the lowest
metric value.
Note: You cannot set two routing protocols to
Leaves the RIP configuration mode.
Sets how long (in seconds) the Switch waits before
removing the invalid route from the routing table.
Sets how long (in seconds) the Switch waits for
route updates before a route is declared no longer
valid. The metric of route will then be set to 16,
which means the route is considered unreachable.
Timeout Timer should be greater than Update
Timer.
Sets the duration of the Update Timer (in seconds)
to specify how often the Switch broadcasts its
routing table and incorporates routing table
information sent from other routers.
Disables RIP on the Switch.
Enters the configuration mode for this routing
domain.
Ethernet Switch CLI Reference Guide
278
have the same administrative distance.
have the same administrative distance.
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13