ZyXEL Communications XS3800-28 Cli Reference Manual page 173

Check the Switch IPv6 address(es) you want to ping. In this example, there are two IPv6 addresses in
2
VLAN 1. One is a link-local address (fe80::219:cbff:fe00:1/64) and the other one is a global address
(2001::1234/64).
sysname# show ipv6
VLAN ID : 1
IPv6 Status : Enable
Origin IP Address/PrefixLength
--------- ------------------------------------------- ---------- -------
manual fe80::219:cbff:fe00:1/64
manual 2001::1234/64
In order to access the Switch through its link-local address, do the address conversion (See
3
page 172).
Use a dash "-" to replace each colon ":" in an IPv6 address. Then the address becomes:
3a
fe80--219-cbff-fe00-1
In the step 1, the Ethernet interface identifier you want to use to connect to the Switch is "%4".
3b
Replace the percentage character "%" with "s" and then append it to the address. The address
becomes:
fe80--219-cbff-fe00-1s4
Append ".ipv6-literal.net" at the end. The address becomes:
3c
fe80--219-cbff-fe00-1s4.ipv6-literal.net
Open an Internet Explorer 7.0 browser and type http://fe80--219-cbff-fe00-1s4.ipv6-
literal.net. The login page appears.
Chapter 42 IPv6 Commands
Ethernet Switch CLI Reference Guide
173
Status Expire
preferred permanent
preferred permanent
Table 122 on