ZyXEL Communications XS3800-28 Cli Reference Manual page 164

Table 116 ipv6 nd Command Summary
COMMAND
interface vlan <1-4094>
ipv6 nd dad-attempts <0-600>
ipv6 nd managed-config-flag
ipv6 nd ns-interval <1000-
3600000>
ipv6 nd other-config-flag
ipv6 nd prefix <ipv6-prefix>/
<prefix-length> <[valid-
lifetime <0-4294967295>]
[preferred-lifetime <0-
4294967295>] [no-autoconfig]
[no-onlink] [no-advertise]>
ipv6 nd prefix <ipv6-prefix>/
<prefix-length>
ipv6 nd ra interval minimum <3-
1350> maximum <4-1800>
ipv6 nd ra lifetime <0-9000>
ipv6 nd ra suppress
ipv6 nd reachable-time <1000-
3600000>
Chapter 42 IPv6 Commands
DESCRIPTION
Enters config-route-domain mode for the specified
VLAN. Creates the VLAN, if necessary.
Sets the number of consecutive neighbor solicitations
the Switch sends for this VLAN.
The Switch uses Duplicate Address Detection (DAD)
with neighbor solicitation and advertisement messages
to check whether an IPv6 address is already in use
before assigning it to an interface, such as the link-
local address it creates through stateless address
autoconfiguration for this VLAN.
To turn off the DAD for this VLAN, set the number of
DAD attempts to 0.
Configures the Switch to set the "managed address
configuration" flag (the M flag) to 1 in IPv6 router
advertisements, which means hosts use DHCPv6 to
obtain IPv6 stateful addresses.
Specifies the time interval (in milliseconds) at which
neighbor solicitations are re-sent for this VLAN.
Configures the Switch to set the "Other stateful
configuration" flag (the O flag) to 1 in IPv6 router
advertisements, which means hosts use DHCPv6 to
obtain additional configuration settings, such as DNS
information.
Sets the Switch to include the specified IPv6 prefix,
prefix length and optional parameters in router
advertisements for this VLAN.
valid-lifetime: sets how long in seconds the prefix is
valid for on-link determination.
preferred-lifetime: sets how long (in seconds) that
addresses generated from the prefix via stateless
address autoconfiguration remain preferred.
no-autoconfig: indicates the hosts can not use this
prefix for stateless address autoconfiguration.
no-onlink: indicates this prefix can not be used for
on-link determination.
no-advertise: sets the Switch to not include the
specified IPv6 prefix, prefix length and optional
parameters in router advertisements for this VLAN.
Sets the Switch to include the specified IPv6 prefix and
prefix length in router advertisements for this VLAN.
Specifies the minimum and maximum time intervals at
which the Switch sends router advertisements for this
VLAN.
Sets how long (in seconds) the router in router
advertisements can be used as a default router for this
VLAN.
Sets the Switch to not send router advertisements and
responses to router solicitations for this VLAN.
Specifies how long (in milliseconds) a neighbor is
considered reachable for this VLAN.
Ethernet Switch CLI Reference Guide
164
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13