ZyXEL Communications XS3800-28 Cli Reference Manual page 53

Table 32 CFM Command Summary (continued)
COMMAND
ethernet cfm ma <ma-index> format
<vid|string|integer> name <ma-name>
md <md-index> primary-vlan <1-4094>
cc-interval
<100ms|1s|10s|1min|10min>
mhf-creation < none | default |
explicit>
id-permission < none | chassis
| management | chassis-
management>
exit
remote-mep <mep-id>
mep <mep-id> interface port-
channel <port> direction
<up|down> priority <0-7>
mep <mep-id> interface port-
channel <port> direction
<up|down> priority <0-7>
inactive
mep <mep-id> interface port-
channel <port> direction
<up|down> priority <0-7> cc-
enable
no remote-mep <mep-id>
Chapter 13 CFM Commands
DESCRIPTION
Creates an MA (Maintenance Association) and
defines its VLAN ID under the MD. You can also define
the format which the Switch uses to send this MA
information in the domain (MD).
ma-name: Enters a VLAN ID, a descriptive name or a 2-
octet integer for the MA.
Note: If you set the format to vid, the VLAN ID
Sets how often an MEP sends a connectivity check
message (CCM).
Sets MHF (MIP Half Function).
Select none and no MIP can be created
automatically for this MA.
Select default to automatically create MIPs for this
MA and on the ports belonging to this MA's VLAN
when there are no lower configured MD levels or
there is an MEP at the next lower configured MD level
on the port.
Select explicit to automatically create MIPs for this
MA and on the ports belonging to this MA's VLAN only
when there is an MEP at the next lower configured MD
level on the port.
Sets what's to be included in the sender ID TLV (Type-
Length-Value) transmitted by CFM packets.
Select none to not include the sender ID TLV.
Select chassis to include the chassis information.
Select management to include the management
information.
Select chassis-management to include both chassis
and management information.
Exits from the config-ma mode.
Sets a remote MEP in an MA.
Sets an MEP in an MA.
up|down: The traffic direction.
0-7: The priority value of the CCMs or LTMs transmitted
by the MEP. 1 is the lowest, then 2, 0 and 3 ~ 7.
Disables a specified MEP.
Enables Connectivity Check (CC) to allow an MEP
sending Connectivity Check Messages (CCMs)
periodically to other MEPs.
Deletes a specified destination MEP.
Ethernet Switch CLI Reference Guide
53
should be the same as the VLAN ID you
use to identify the MA.
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13