ZyXEL Communications XS3800-28 Cli Reference Manual page 227

60.2 Command Summary
The following section lists the commands for this feature.
Table 157 NLB Command Summary
COMMAND
nlb mac-forward name <name> mac
<mac> vlan <vlan-id> interface
port-channel <port-list>
no nlb mac-forward mac <mac>
vlan <vlan-id>
Chapter 60 NLB Commands
DESCRIPTION
Configures to which MAC addresses and ports the Switch
should forward the incoming NLB traffic.
: Enters a descriptive name for identification
<name>
purposes for this rule.
: Enters a multicast or unicast MAC address of a
<mac>
cluster.
The last binary bit of the first octet pair in a multicast MAC
address must be 1. For example, the first octet pair
00000001 is 01 and 00000011 is 03 in hexadecimal, so
01:00:5e:00:00:0A and 03:00:5e:00:00:27 are valid multicast
MAC addresses.
The last binary bit of the first octet pair in a unicast MAC
address must be 0. For example, the first octet pair
00000000 is 00 and 00000010 is 02 in hexadecimal, so
00:00:5e:00:00:0A and 02:00:5e:00:00:27 are valid unicast
MAC addresses.
<vlan-id>
don't have a specific target VLAN, enter 1.
The Switch will forward traffic to ports in this VLAN group.
<port-list>
Switch to forward the incoming NLB traffic.
You can enter multiple ports separated by (no space)
comma (,) or hyphen (-). For example, enter "3-5" for ports
3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
Removes the specified MAC forwarding rule.
: Enters a multicast or unicast MAC address of a
<mac>
cluster.
<vlan-id>
Ethernet Switch CLI Reference Guide
227
: Enters the VLAN identification number. If you
: Enters the port(s) to which you want the
: Enters the VLAN identification number.
M P
C 13
C 13