ZyXEL Communications XS3800-28 Cli Reference Manual page 168

42.3 Command Examples
This example shows how to enable IPv6 in VLAN 1 and display the link-local address the Switch
automatically generated and other IPv6 information for the VLAN.
sysname# config
sysname(config)# interface vlan 1
sysname(config-vlan)# ipv6
sysname(config-vlan)# exit
sysname(config)# exit
sysname# show ipv6 vlan 1
VLAN : 1 (VLAN1)
IPv6 is enabled.
MTU is 1500 bytes.
ICMP error messages limited to 10 every 100 milliseconds.
Stateless Address Autoconfiguration is disabled.
Link-Local address is fe80::219:cbff:fe6f:9159 [preferred]
Global unicast address(es):
Joined group address(es):
ff02::2
ff01::1
ff02::1
ff02::1:ff6f:9159
ND DAD is enabled, number of DAD attempts: 1
ND NS-interval is 1000 milliseconds
ND reachable time is 30000 milliseconds
ND router advertised managed config flag is disable
ND router advertised other config flag is disable
ND router advertisements are sent every 200 to 600 seconds
ND router advertisements lifetime 1800 seconds
This example shows how to manually configure two IPv6 addresses (one uses the EUI-64 format, one
doesn't) in VLAN 1, and then display the result. Before using ipv6 address commands, you have to
enable IPv6 in the VLAN and this has the Switch generate a link-local address for the interface.
Chapter 42 IPv6 Commands
Ethernet Switch CLI Reference Guide
168