Static Multicast Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Static Multicast Commands

Use these commands to tell the Switch how to forward specific multicast frames to specific port(s). You
can also configure which to do with unknown multicast frames using the router igmp unknown-
multicast-frame command (see
84.1 Command Summary
The following section lists the commands for this feature.
Table 197 multicast-forward Command Summary
COMMAND
show mac address-table multicast
multicast-forward name <name>
mac <mac-addr> vlan <vlan-id>
inactive
multicast-forward name <name>
mac <mac-addr> vlan <vlan-id>
interface port-channel <port-
list>
no multicast-forward mac <mac-
addr> vlan <vlan-id>
no multicast-forward mac <mac-
addr> vlan <vlan-id> inactive
Table 88 on page
DESCRIPTION
Displays the multicast MAC address table.
Creates a new static multicast forwarding rule. The rule
name can be up to 32 printable ASCII characters.
mac-addr: Enter a multicast MAC address which identifies
the multicast group. The last binary bit of the first octet pair
in a multicast MAC address must be 1. For example, the
first octet pair 00000001 is 01 and 00000011 is 03 in
hexadecimal, so 01:00:5e:00:00:0A and 03:00:5e:00:00:27
are valid multicast MAC addresses.
vlan-id: A VLAN identification number.
Note: Static multicast addresses do not age out.
Associates a static multicast forwarding rule with specified
port(s) within a specified VLAN.
Removes a specified static multicast rule.
Activates a specified static multicast rule.
Ethernet Switch CLI Reference Guide
313
C
H A P T E R
124).
84
M P
E 3
C 13
C 13
C 13
C 13