ZyXEL Communications XS3800-28 Cli Reference Manual page 183

Chapter 44 Link Layer Discovery Protocol (LLDP) Commands
system-description TLVs) on port 2. This example also shows the LLDP settings on port 2 and global LLDP
settings on the Switch.
sysname# configure
sysname(config)# lldp
sysname(config)# interface port-channel 2
sysname(config-interface)# lldp admin-status tx-rx
sysname(config-interface)# lldp basic-tlv management-address
sysname(config-interface)# lldp basic-tlv port-description
sysname(config-interface)# lldp basic-tlv system-description
sysname(config-interface)# exit
sysname(config)# exit
sysname# show lldp config interface port-channel 2
LLDP Port Configuration:
Port AdminStatus
2 tx-rx
Basic TLV Flags: (P)Port Description, (N)System Name, (D)System
Description
(C)System Capabilities, (M)Management Address
802.1 TLV Flags: (P)Port & Protocol VLAN ID, (V)Port VLAN ID
802.3 TLV Flags: (L)Link Aggregation, (M)MAC/PHY Configuration/Status
(F)Maximun Frame Size, (P)Power Via MDI
sysname# show lldp config
LLDP Global Configuration:
Active: Yes
Transmit Interval: 30 seconds
Transmit Hold: 4
Transmit Delay: 2 seconds
Reinitialize Delay: 2 seconds
sysname#
See Chapter 20 on page 77
This example shows global Switch LLDP settings.
sysname# show lldp config
LLDP Global Configuration:
Active: No
Transmit Interval: 30 seconds
Transmit Hold: 4
Transmit Delay: 2 seconds
Reinitialize Delay: 2 seconds
sysname#
The following table describes the labels in this screen.
Switch LLDP settings
Table 125
LABEL
Active
Transmit Interval
Notification
Disable
for DCB configuration and examples.
DESCRIPTION
This displays whether LLDP is enabled on the Switch. It is disabled by default.
This displays how long the Switch waits before sending LLDP packets.
Ethernet Switch CLI Reference Guide
183
BasicTLV Dot1TLV
P-D-M --
Dot3TLV
----