ZyXEL Communications XS3800-28 Cli Reference Manual page 172

IPv6 is installed and enabled by default in Windows Vista. Use the "ipconfig" command to check your
automatic configured IPv6 address as well. You should see at least one IPv6 address available for the
interface on your computer.
42.5 Example - HTTP Accessing the Switch Using IPv6
How you access the Switch using HTTP varies depending on the operating system (OS) and the type of
browser you use and the type of address you want to access.
Note: It's recommended to use Internet Explorer 7.0 or FireFox to access the Switch's web GUI.
Table 122 Specifying the Switch Address for HTTP Access
OS
Windows
XP
Windows
Vista
This example shows you how to access the Switch using HTTP on Windows XP.
Make sure you have enabled IPv6 on your computer (see Section 42.4). Use the ipconfig command in
1
the command prompt to check the IPv6 address on your computer. The example uses an interface with
address "fe80::2d0:59ff:feb8:103c" to access the Switch. So its Ethernet interface identifier is %4 and will
be used later to make a ping.
C:\>ipconfig
Windows IP Configuration
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix
IP Address. . . . . . . . . . . . : 10.1.1.46
Subnet Mask . . . . . . . . . . . : 255.255.255.0
IP Address. . . . . . . . . . . . : fe80::2d0:59ff:feb8:103c%4
Default Gateway . . . . . . . . . : 10.1.1.254
Chapter 42 IPv6 Commands
DESTINATION INTERNET EXPLORER 7.0
A link-local address Use http://address
The address should be converted using the following procedure.
1. Use a dash "-" to replace each colon ":" in an IPv6 address.
2. Append the Ethernet interface identifier you want to use to connect to the
3. Append ".ipv6-literal.net" at the end.
For example, the Switch uses an address fe80::1234:5678. The Ethernet interface
identifier you want to use on your computer to access the Switch is %4. You
have to type the following to access the Switch.
http://fe80--1234-5678-1s4.ipv6-literal.net.
A global address Use http://[address]
A link-local address
For example, http://[fe80--1234-5678-1]
A global address
Ethernet Switch CLI Reference Guide
Switch. But replace the percentage character "%" with "s".
. :
172
FIREFOX