ZyXEL Communications XS3800-28 Cli Reference Manual page 16

2.2.2 Command Modes for Privilege Levels 13-14
If the session's privilege level is 13-14, the allowed commands are in one of several modes.
Table 7 Command Modes for Privilege Levels 13-14 and the Types of Commands in Each One
MODE
enable
config
config-interface
config-mvr
config-route-
domain
config-dvmrp
config-igmp
config-ma
config-ospf
config-rip
config-vrrp
Each command is usually in one and only one mode. If a user wants to run a particular command, the
user has to change to the appropriate mode. The command modes are organized like a tree, and users
start in enable mode. The following table explains how to change from one mode to another.
Table 8 Changing Between Command Modes for Privilege Levels 13-14
MODE
enable
config
config-interface
config-mvr
config-vlan
config-route-domain
config-dvmrp
config-igmp
config-ospf
config-rip
config-vrrp
Chapter 2 Privilege Level and Command Mode
PROMPT
sysname#
sysname(config)#
sysname(config-interface)#
sysname(config-mvr)#
sysname(config-if)#
sysname(config-dvmrp)#
sysname(config-igmp)#
sysname(config-ma)#
sysname(config-ospf)#
sysname(config-rip)#
sysname(config-vrrp)#
ENTER MODE
--
configure
interface port-channel <port-list>
mvr <1-4094>
vlan <1-4094>
interface route domain <ip-address>/<mask-bits>
router dvmrp
router igmp
router ospf <router-id>
router rip
router vrrp network <ip-address>/<mask-bits>
vr-id <1~7> uplink-gateway <ip-address>
Ethernet Switch CLI Reference Guide
COMMAND FUNCTIONS IN THIS MODE
Display current configuration, diagnostics,
maintenance.
Configure features other than those below.
Configure ports.
Configure multicast VLAN.
Enable and enter configuration mode for an IPv4 or
IPv6 routing domain.
Configure Distance Vector Multicast Routing Protocol
(DVRMP).
Configure Internet Group Management Protocol
(IGMP).
Configure an Maintenance Association (MA) in
Connectivity Fault Management (CFM).
Configure Open Shortest Path First (OSPF) protocol.
Configure Routing Information Protocol (RIP).
Configure Virtual Router Redundancy Protocol (VRRP).
16
LEAVE MODE
--
exit
exit
exit
exit
exit
exit
exit
exit
exit
exit