ZyXEL Communications XS3800-28 Cli Reference Manual page 81

The following table lists the commands for this feature.
Table 56 ets Command Summary
COMMAND
traffic-class <id> scheduler <sp |
ets <weight>> [name <name>]
no traffic-class <id>
show traffic-class
interface port-channel <port-list>
ets
ets traffic-class binding <tc-
id0> <tc-id1> <tc-id2> <tc-id3>
<tc-id4> <tc-id5> <tc-id6> <tc-
id7>
no ets traffic-class binding
unicast-nonunicast-weight
<weight> <weight>
20.2.4 ETS Command Example 1
This is an example where the non-editable default traffic class, ID 0, uses SP queuing. LAN and SAN traffic
uses WFQ queuing with equal weighting of 50 each.
Table 57 ETS Example Traffic Classes
TRAFFIC CLASS ID
0
1
2
The guaranteed minimum bandwidth for both SAN and LAN traffic is 2.5Gbps with a link bandwidth of
10Gbps.
Table 58 ETS Example Traffic Bandwidths
NAME
Default
SAN
LAN
Create and name traffic class IDs, with weights for the non-SP traffic type.
sysname# configure
sysname(config)# traffic-class 1 scheduler ets 50 name LAN
sysname(config)# traffic-class 2 scheduler ets 50 name SAN
Chapter 20 Data Center Bridging Commands
GUARANTEED BANDWIDTH
SP
50
50
INCOMING TRAFFIC
BANDWIDTH (GBPS)
5
3
4
Ethernet Switch CLI Reference Guide
81
DESCRIPTION
Creates a WFQ or SP traffic class with ID, weight and
(optional) name.
Deletes the SP/WFQ traffic class with specified ID.
Shows a summary of traffic class(es) created on the
Switch.
Enters config-interface mode for the specified port(s).
Enable Enhanced Transmission Selection (ETS) queuing
method. See Chapter 71 on page 269
queuing methods.
Binds priorities to a traffic class(es) on the specified
port(s).
Resets traffic class binding priorities to default settings
on the specified port(s).
Sets the unicast to non-unicast traffic weight ratio on
the specified port(s).
NAME
GUARANTEED
MINIMUM BANDWIDTH
5 (SP)
(10-5) * (50/(50+50)) = 2.5
(10-5) * (50/(50+50)) = 2.5
for other
Default
SAN
LAN
OUTGOING TRAFFIC
BANDWIDTH (GBPS)
5
2.5
2.5
M P
C 13
C 13
E 3
C 13
C 13
C 13
C 13
C 13