ZyXEL Communications XS3800-28 Cli Reference Manual page 279

Table 177 rip Command Summary (continued)
COMMAND
ip rip direction
<Outgoing|Incoming|Both|None>
version <v1|v2b|v2m>
interface vlan <vlan-id>
ipv6 rip
no ipv6 rip
ipv6 rip method <no-
horizon|split-horizon|poison-
reverse>
ipv6 rip metric <metric>
show ip rip database
show ipv6 rip
show ipv6 rip database
74.3 Command Examples
This example:
• Enables RIP.
• Enters the IP routing domain 172.16.1.1 with subnet mask 255.255.255.0.
• Sets the RIP direction in this routing domain to Both and the version to 2 with subnet broadcasting
(v2b); the Switch will send and receive RIP packets in this routing domain.
sysname(config)# router rip
sysname(config-rip)# exit
sysname(config)# interface route-domain 172.16.1.1/24
sysname(config-if)# ip rip direction Both version v2b
Chapter 74 RIP Commands
DESCRIPTION
Sets the RIP direction and version in this routing
domain.
Enters the configuration mode for this VLAN
interface.
Enables IPv6 RIP on the VLAN interface.
Disables IPv6 RIP on the VLAN interface.
Specifies the mechanism used by the interface to
prevent routing loops.
no-horizon
interface to prevent routing loops.
split-horizon
sending back the routing information received and
learned from a neighbor. This also helps save
bandwidth.
poison-reverse
metric of routes learned from a neighbor to 16 and
send the routing information back. The neighbor will
then delete the routes from its routing table.
Enters a number that approximates the cost for this
link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a
good number.
metric
Displays the RIP configuration settings on the
Switch.
Shows whether IPv6 RIP is enabled on the Switch.
Displays the IPv6 RIP configuration settings on the
Switch.
Ethernet Switch CLI Reference Guide
279
: to not use any mechanism on this
; to prevent the interface from
: to have the interface set the
: 1-15
M P
C 13
C 13
C 13
C 13
c 13
c 13
E 3
E 3
E 3