ZyXEL Communications XS3800-28 Cli Reference Manual page 211

This example displays the mirror settings of the Switch after you configured in the example above.
sysname# show mirror
Mirroring: enable
Monitor port: 3
Mirrored port: 1,4-6
Ingress:
Egress: 1,4-6
Both:
This example creates an RMirror VLAN with a VLAN ID of 200 on the Switch, sets port 6 as the reflector
port and sets the priority of mirrored traffic to 3 in this RMirror VLAN when the Switch is the source device.
This example also specifies the ports (4 and 5) on which traffic will be mirrored and shows the RMirror
VLAN settings.
sysname# configure
sysname(config)# rmirror vlan 200
sysname(config-rmirror)# source reflector-port 6
sysname(config-rmirror)# source reflector-port
sysname(config-rmirror)# source 8021p-priority 3
sysname(config-rmirror)# source mirror-port 4,5
sysname(config-rmirror)# exit
sysname(config)# exit
sysname# show rmirror vlan 200
RMirror VLAN:200
----------------------------------------
Source
802.1p priority
Mirror-port
Ingress
Egress
Both
Reflector-port
Active
Port
Destination
Monitor-port
Connected-port
sysname#
Chapter 55 Mirror Commands
Active=Yes
:3
:
:
:
:4-5
:Yes
:6
:
:
Ethernet Switch CLI Reference Guide
211