Additional Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to configure or perform additional features on the Switch.
106.1 Command Summary
The following section lists the commands for this feature.
Table 231 Command Summary: Changing Modes or Privileges
COMMAND
enable
enable <0-14>
disable
configure
interface port-channel <port-
list>
mvr <1-4094>
vlan <1-4094>
exit
logout
Table 232 Command Summary: Additional Enable Mode
COMMAND
baudrate <1|2|3|4|5>
boot config <index>

Additional Commands

Ethernet Switch CLI Reference Guide
C
H A P T E R
DESCRIPTION
Changes the session's privilege level to 14 and puts the session
in enable mode (if necessary). The user has to provide the
enable password. See Section 2.1.3.1 on page
Raises the session's privilege level to the specified level and
puts the session in enable mode if the specified level is 13 or 14.
The user has to provide the password for the specified privilege
level. See Section 2.1.3.2 on page
Changes the session's priority level to 0 and changes the mode
to user mode. See Section 2.1.3.3 on page
Changes the mode to config mode.
Enters config-interface mode for the specified port(s).
Enters config-mvr mode for the specified MVR (multicast VLAN
registration). Creates the MVR, if necessary.
Enters config-vlan mode for the specified VLAN. Creates the
VLAN, if necessary.
Returns to the previous mode.
Logs out of the CLI.
DESCRIPTION
Changes the console port speed.
1: 38400 bps
2: 19200 bps
3: 9600 bps
4: 57600 bps
5: 115200 bps
Restarts the Switch (cold reboot) with the specified
configuration file.
363
106
14.
14.
15.
M P
E 0
E 0
E 13
E 13
C 13
C 13
C 13
C 13
E 0
M P
E 13
E 13