ZyXEL Communications XS3800-28 Cli Reference Manual page 295

private VLAN rule for VLAN 200 to put ports 3, 4 and 5 in the isolated port list. In this example, the
designated port 7 is added to the isolated port list after smart isolation is enabled.
sysname# configure
sysname(config)# spanning-tree mode rstp
sysname(config)# spanning-tree
sysname(config)# spanning-tree priority 32768
sysname(config)# spanning-tree 3-5, 7-8
sysname(config)# vlan 200
sysname(config-vlan)# fixed 3-5, 7-8
sysname(config-vlan)# untagged 3-5, 7-8
sysname(config-vlan)# exit
sysname(config)# private-vlan name pvlan-200 vlan 200 promiscuous-port 7-8
sysname(config)# smart-isolation
sysname(config)# exit
sysname# show smart-isolation
smart isolation enable
Private VLAN:
Original VLAN:
VLAN 200
isolated 3-5
promiscuous 7-8
Smart Isolated VLAN:
VLAN 200
isolated 3-5,7
promiscuous 8
sysname#
The following table describes the labels in this screen.
Table 186 show smart-isolation
LABEL
Port isolation
original isolated ports
smart isolated ports
Private VLAN
Original VLAN
Smart Isolated VLAN
Chapter 79 Smart Isolation Commands
DESCRIPTION
This section is available only when you have configured port isolation on the Switch.
The following fields display the port isolation information before and after smart
isolation is enabled.
This field displays the isolated port list before smart isolation is enabled.
This field displays the isolated port list after smart isolation is enabled.
This section is available only when you have configured private VLAN on the Switch.
The following fields display the private VLAN information before and after smart
isolation is enabled.
This section displays the VLAN ID and isolated and promiscuous port list before smart
isolation is enabled
This section displays the VLAN ID and isolated and promiscuous port list after smart
isolation is enabled
Ethernet Switch CLI Reference Guide
295