ZyXEL Communications XS3800-28 Cli Reference Manual page 374

This example displays run-time SFP (Small Form Factor Pluggable) parameters on port 21 on the Switch.
You can also see the alarm and warning thresholds for temperature, voltage, transmission bias,
transmission and receiving power as shown.
sysname# show interface transceiver 21
Transceiver Information
Port
Vendor
Part Number
Series Number
Revision
Date Code
Transceiver
++ : high alarm, + : high warn, - : low warn, -- : low alarm.
-------------- ----------- ------------ ----------- ----------- -----------
Temperature(C) ++
Voltage(V)
Tx Bias(mA)
Tx Power(dBm)
Rx Power(dBm) +
sysname#
This example displays the firmware version the Switch is currently using..
sysname# show version
Current ZyNOS version: V3.80(BBA.3)b1 | 04/17/2008
This example runs an internal loopback test on ports 3-6.
sysname# test interface port-channel 3-6
Testing internal loopback on port 3 :Passed!
Ethernet Port 3 Test ok.
Testing internal loopback on port 4 :Passed!
Ethernet Port 4 Test ok.
Testing internal loopback on port 5 :Passed!
Ethernet Port 5 Test ok.
Testing internal loopback on port 6 :Passed!
Ethernet Port 6 Test ok.
This example displays route information to an Ethernet device with IP address
sysname> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:
sysname>
Chapter 106 Additional Commands
: 21 (SFP)
: ZyXEL
: SFP-LX-10-D
: S081133000074
: V1.0
: 2008-08-11
: 1000BASE-LX
Current High Alarm
Threshold
38.00 -1.00
3.36 3.50
14.53 100.05
-5.80 -2.99
-3.36 -2.99
Ethernet Switch CLI Reference Guide
374
High Warn Low Warn
Threshold Threshold
75.00 5.00
3.45 3.15
90.04 7.00
-3.49 -8.96
-3.49 -20.50
Low Alarm
Threshold
0.00
3.10
6.00
-9.50
-21.02
1.100.
192.168.