ZyXEL Communications XS3800-28 Cli Reference Manual page 71

This example configures port 4 as the tagged port in VLAN 20 and the untagged port in VLAN 100. This
example also configures 200 as the PVID on port 4.
sysname# config
sysname(config)# interface port-channel 4
sysname(config-interface)# switchport mode hybrid
sysname(config-interface)# switchport hybrid allowed vlan 20 tagged
sysname(config-interface)# switchport hybrid allowed vlan 100 untagged
sysname(config-interface)# switchport hybrid pvid 200
sysname(config-interface)# exit
This example shows the VLAN table.
sysname# show vlan
The Number of VLAN :
Idx. VID Status
---- ---- ---------
---
1 1 Static
2 20 Static
3 100 Static
4 200 Static
The following table describes the labels in this screen.
Table 48 show vlan
LABEL
The Number of VLAN
Idx.
VID
Status
Elap-Time
TagCtl
Chapter 17 CLV Commands
4
Elap-Time TagCtl
----------- ----------------------------------
145:03:37 Access :1-3,6-52
Trunk
1:47:09 Access :
Trunk
26:04:36 Access :4
Trunk
2:01:54 Access :
Trunk
DESCRIPTION
This field displays the number of VLANs on the Switch.
This field displays an entry number for each VLAN.
This field displays the VLAN identification number.
This field displays how this VLAN was added to the Switch.
Dynamic: The VLAN was added via GVRP.
Static: The VLAN was added as a permanent entry
Other: The VLAN was added in another way, such as Multicast VLAN Registration
(MVR).
This field displays how long it has been since a dynamic VLAN was registered or a static
VLAN was set up.
This field displays untagged and tagged ports.
Access: These ports do not tag outgoing frames with the VLAN ID.
Trunk: These ports tag outgoing frames with the VLAN ID.
Ethernet Switch CLI Reference Guide
71
:
:4
:1-3
: