ZyXEL Communications XS3800-28 Cli Reference Manual page 180

Chapter 44 Link Layer Discovery Protocol (LLDP) Commands
Table 124 lldp Command Summary (continued)
COMMAND
lldp med location coordinate
[latitude <north|south>
<value>][longitude <west|east >
<value>][altitude
<meters|floor> <value>][datum
<WGS84|NAD83-NAVD88|NAD83-
MLLW>]
lldp med location elin
<number>
lldp med network-policy
<voice|voice-signaling|guest-
voice|guest-voice-
signaling|softphone-
voice|video-
conferencing|streaming-
video|video-signaling>
[tagged|untagged][vlan <vlan-
id>][priority <priority>][dscp
<dscp>]
lldp med topology-change-
notification
lldp notification
lldp org-specific-tlv dot1
port-protocol-vlan-id
lldp org-specific-tlv dot1
port-vlan-id
lldp org-specific-tlv dot3
link-aggregation
lldp org-specific-tlv dot3 mac-
phy
lldp org-specific-tlv dot3 max-
frame-size
lldp org-specific-tlv dot3
power-via-mdi
lldp org-specific-tlv med
location
lldp org-specific-tlv med
network-policy
no lldp admin-status
no lldp basic-tlv management-
address
DESCRIPTION
Sets coordinate location information.
Latitude value: -90º to 90º
Longtitude value: -180º to 180º
Altitude value: -2097151 to 2097151 in meters or -
2097151 to 2097151 in the number of floors
Sets location information of a caller by its ELIN
(Emergency Location Identifier Number).
number: a ten-digit phone number
Sets a network policy for the specified application.
Enables the sending of LLDP-MED topology change
traps when devices are connected to or
disconnected from the specified ports.
Enables the sending of LLDP traps.
Enables the sending of IEEE 802.1 Port and Protocol
VLAN ID TLVs, which contains the VLAN ID and
indicates whether the VLAN is enabled and
supported.
Enables the sending of IEEE 802.1 Port VLAN ID TLVs,
which contains the port's VLAN ID.
Enables the sending of IEEE 802.3 Link Aggregation
TLVs, which shows the link aggregation status of the
port(s).
Enables the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLV, which shows duplex and
rate settings and indicates whether auto negotiation
is supported on the port.
Enables the sending of IEEE 802.3 Maximum Frame Size
TLVs on the port(s).
Enables the sending of IEEE 802.3 Power via MDI TLVs,
which indicates whether power can be supplied via a
media dependent interface (MDI) on the port(s).
Enables the sending of location TLVs on the port(s).
Enables the sending of network policy TLVs on the
port(s).
Resets the port(s) to default setting on sending or
receiving LLDP packets.
Disables the sending of Management Address TLVs on
the port(s).
Ethernet Switch CLI Reference Guide
180
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13