ZyXEL Communications XS3800-28 Cli Reference Manual page 331

Table 212 lacp Command Summary (continued)
COMMAND
no lacp
lacp system-priority <1-65535>
93.2 Command Examples
This example activates trunk 1 and places ports 5-8 in the trunk using static link aggregation.
sysname(config)# trunk t1
sysname(config)# trunk t1 interface 5-8
This example disables trunk one (T1) and removes ports 1, 3, 4, and 5 from trunk two (T2).
sysname(config)# no trunk T1
sysname(config)# no trunk T2 interface 1,3-5
This example looks at the current trunks.
sysname# show trunk
Group ID 1:
Status: -
Member number: 0
Group ID 2:
Status: -
Member number: 0
Group ID 3:
Status: -
Member number: 0
The following table describes the labels in this screen.
Table 213 show trunk
LABEL
Group ID
Status
Member Number
Member
Chapter 93 Trunk Commands
DESCRIPTION
Disables the link aggregation control protocol (dynamic
trunking) on the Switch.
Sets the priority of an active port using LACP.
inactive
inactive
inactive
DESCRIPTION
This field displays the trunk ID number and the current status.
inactive: This trunk is disabled.
active: This trunk is enabled.
This field displays how the ports were added to the trunk.
-: The trunk is disabled.
Static: The ports are static members of the trunk.
LACP: The ports joined the trunk via LACP.
This field shows the number of ports in the trunk.
This field is displayed if there are ports in the trunk.
This field displays the member port(s) in the trunk.
Ethernet Switch CLI Reference Guide
331
M P
C 13
C 13