ZyXEL Communications XS3800-28 Cli Reference Manual page 304

Select a Switch to be the master. Change its mode to stacking mode. You will see a message asking you
1
to confirm the change. Press [Y] to confirm and the Switch will reboot automatically using a new
config01.
After reboot completes, the master LED will turn on.
2
Force the Switch to be master, configure stacking priority to a high value, such as 63 and set its slot ID to
3
1.
sysname# configure terminal
sysname(config)# stacking
System will erase all configuration and reboot. Continue? [y/N]y
< reboot.......>
sysname(config)# stacking force-master
sysname(config)# stacking priority 63
sysname(config)# stacking slot-id 1 renumber 1
Change a second Switch to stacking mode and wait for it to finish rebooting automatically. This master
4
LED will also turn on.
sysname# configure terminal
sysname(config)# stacking
System will erase all configuration and reboot. Continue? [y/N]y
< reboot.......>
Connect the two Switches using the stacking ports for the Switch defined.
5
The second Switch master LED will then turn off, and its Sys LED will blink while it's initializing. Please wait
6
until it stops blinking, indicating that it has joined the stack.
Repeat steps 4 to 6 to connect other Switches to the stack.
7
Chapter 81 Stacking Commands
Ethernet Switch CLI Reference Guide
304