Mac Authentication Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to configure MAC authentication on the Switch.
50.1 MAC Authentication Overview
MAC authentication allows you to validate access to a port based on the MAC address and password
of the client.
Note: You also need to configure a RADIUS server (see
See also Chapter 33 on page 121
page 253 for port security commands.
50.2 Command Summary
The following section lists the commands for this feature.
Table 139 mac-authentication Command Summary
COMMAND
show mac-authentication
show mac-authentication config
mac-authentication
mac-authentication case
<upper|lower>
mac-authentication delimiter
<dash|colon|none>
MAC Authentication
for IEEE 802.1x port authentication commands and
DESCRIPTION
Displays MAC authentication settings for the Switch.
Displays MAC authentication settings on a port by port
basis with authentication statistics for each port.
Enables MAC authentication on the Switch.
Sets the case (upper or lower) the external server requires
for using MAC addresses as the account username and
password.
For example, use mac-authentication case upper and
mac-authentication delimiter dash if you need to
use a MAC address formatted like 00-11-AC-01-A0-11 as
the username and password.
Specifies the separator the external server uses for the two-
character pairs within MAC addresses used as the
account username and password.
For example, use mac-authentication case upper and
mac-authentication delimiter dash if you need to
use a MAC address formatted like 00-11-AC-01-A0-11 as
the username and password.
Ethernet Switch CLI Reference Guide
198
C
H A P T E R
Commands
Chapter 72 on page
50
273).
Chapter 66 on
M P
E 3
E 3
C 13
C 13
C 13