ZyXEL Communications XS3800-28 Cli Reference Manual page 364

Table 232 Command Summary: Additional Enable Mode (continued)
COMMAND
<1|2>
boot image
cable-diagnostics <port-
list>
ping <ip|host-name> [vlan
<vlan-id>] [size <0-1472>] [-
t]
ping help
reload config [1|2]
reset slot <slot-list>
show al1arm-status
show cpu-utilization
show cpu-utilization process
show except-smac
show hardware-monitor <C|F>
show interfaces status
show interfaces transceiver
<port-list>
show memory
show power-source-status
show rootguard
show sfp <port-list>
show slot
show slot config
show slot config <slot-list>
show system-information
Chapter 106 Additional Commands
DESCRIPTION
The Switch supports dual firmware images, ras-0 and ras-1. Run
this command, where <index> is 1 (ras-0) or 2 (ras-1) to specify
which image is updated when firmware is loaded using the
web configurator and to specify which image is loaded when
the Switch starts up.
Performs a physical wire-pair test of the Ethernet connections
on the specified port(s).
Sends Ping packets to the specified Ethernet device.
vlan-id: Specifies the VLAN ID to which the Ethernet device
belongs.
size <0-1472>: Specifies the size of the Ping packet.
-t: Sends Ping packets to the Ethernet device indefinitely. Press
[CTRL]+C to terminate the Ping process.
Provides more information about the specified command.
Restarts the system (warm reboot) with the specified
configuration file.
1: config-1
2: config-2
Restarts the card in the selected slot. The card restarts using the
last-saved configuration. Any unsaved changes are lost.
Displays alarm status.
Displays the CPU utilization statistics on the Switch.
Displays the CPU and memory usage of each process.
Displays whether the Switch is to drop the packets with an all-
zero source MAC address (00:00:00:00:00:00).
This command is not available in all models.
Displays current hardware monitor information with the
specified temperature unit (Celsius C or Fahrenheit F).
Displays the summary status of interfaces for all ports on the
Switch.
Displays real-time SFP (Small Form Factor Pluggable) transceiver
information and operating parameters on specified SFP port(s).
The parameters include, for example, module temperature,
module voltage, transmitting and receiving power.
Displays the memory utilization statistics on the Switch.
Displays the status of each power module in the system.
Displays STP mode and root guard information.
Displays real-time SFP (Small Form Factor Pluggable) transceiver
operating parameters on specified SFP port(s). The parameters
include, for example, module temperature, module voltage,
transmitting and receiving power.
Displays general status information about each slot.
Displays what type of card is installed in each slot and its
current operational status.
Displays detailed information about the specified slots.
Displays general system information.
Ethernet Switch CLI Reference Guide
364
M P
E 13
E 13
E 0
E 0
E 13
E 13
E 0
E 0
E 0
E 13
E 0
E 3
E 3
E 3
E 0
E 3
E 3
E 13
E 13
E 13
E 0