ZyXEL Communications XS3800-28 Cli Reference Manual page 234

Table 158 OSPF Command Summary (continued)
COMMAND
area <area-id> stub
no area <area-id> stub
area <area-id> stub no-summary
no area <area-id> stub no-summary
area <area-id> virtual-link <router-
id>
no area <area-id> virtual-link
<router-id>
area <area-id> virtual-link <router-
id> dead-interval <1-65535>
area <area-id> virtual-link <router-
id> hello-interval <1-65535>
area <area-id> virtual-link <router-
id> retransmit-interval <1-65535>
area <area-id> virtual-link <router-
id> transmit-delay <1-65535>
distance <10-255>
interface <interface-type> <interface-
number> area <area-id>
no interface <interface-type>
<interface-number>
redistribute rip
no redistribute rip
Chapter 61 OSPF Commands
Ethernet Switch CLI Reference Guide
234
DESCRIPTION
Enables and sets the area as a stub area.
Disables stub network settings in the area.
Sets the stub area not to send any LSA (Link
State Advertisement).
Sets the stub area to send LSAs (Link State
Advertisements).
Sets the virtual link ID information for the
area.
Deletes the virtual link from the area.
Sets the dead interval for the virtual link in
the area.
Sets the hello interval for the virtual link in the
area.
Sets the retransmission interval for the virtual
link in the area.
Sets the transmission delay for the virtual link
in the area.
When two different routing protocols, such
as RIP and OSPF provide multiple routes to
the same destination, the Switch can use
the administrative distance of the route
source to determine which routing protocol
to use and add the route to the routing
table.
Sets the administrative distance (from 10 to
255) that is assigned to the routes learned by
OSPF.
The lower the administrative distance value
is, the more preferable the routing protocol
is. If two routes have the same administrative
distance value, the Switch uses the route
that has the lowest metric value.
Note: You cannot set two routing
protocols to have the same
administrative distance.
Sets the area ID of an area to associate a
specific VLAN interface with that area.
Removes the specified IPv6 VLAN interface.
Sets the Switch to redistribute RIP routing
information.
Route redistribution allows your Switch to
import and translate external routes
learned through other routing protocols (RIP
and Static) into the OSPF network
transparently.
Sets the Switch not to learn RIP routing
information.
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13