Global Vlan1Q Tagged Vlan Configuration Commands; Garp Status; Garp Timer - ZyXEL Communications Dimension GS-4024 User Manual

GS-4012F/4024 User's Guide

46.2 Global VLAN1Q Tagged VLAN Configuration Commands

This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.

46.2.1 GARP Status

Syntax:
show garp
This command shows the switch's GARP timer settings, including the join, leave and leave all
timers.
An example is shown next.
sysname# show garp

GARP Timer

------------------------
Join Timer = 200
Leave Timer = 600
Leave All Timer = 10000
sysname#
46.2.2 GARP Timer
Syntax:
garp join <msec> leave <msec> leaveall <msec>
where
join <msec>
leave <msec>
leaveall
<msec>
This command sets the switch's GARP timer settings, including the join, leave and leave all
timers.
320
= This sets the duration of the Join Period timer for GVRP in
milliseconds. Each port has a Join Period timer. The allowed Join Time
range is between 100 and 32767 milliseconds; the default is 200
milliseconds.
= This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time
must be two times larger than Join Timer; the default is 600
milliseconds.
= This sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All
Timer must be larger than Leave Timer; the default is 10000
milliseconds.
Chapter 46 IEEE 802.1Q Tagged VLAN Commands