ZyXEL Communications XS3800-28 Cli Reference Manual page 337

95.2 Command Summary
The following section lists the commands for this feature.
Table 216 Vendor ID-based VLAN Command Summary
COMMAND
vendor-id-based-vlan name <name>
source-mac <mac-addr> mask
<mask> <vlan-id> priority <0-7>
[weight <0-255>]
no vendor-id-based-vlan name
<name> source-mac <mac-addr>
mask <mask>
show vendor-id-based-vlan
95.3 Command Example: add source MAC address
This example adds a binding source MAC address to a vendor ID-based VLAN with MAC address
00:a0:c5:01:23:45, mask ff:ff:ff:00:00:00, VLAN ID number 222, priority level 3 and weight 200.
sysname(config)# vendor-id-based-vlan name ex1 source-mac 00:a0:C5:01:23:45
mask ff:ff:ff:00:00:00 vlan 222 priority 3 weight 200
sysname(config)# exit
sysname# show vendor-id-based-vlan
Index Name
----- ----
1
sysname#
Chapter 95 Vendor ID-based VLAN
Source MAC
-----------------
ex1 00:a0:c5:01:23:45
Ethernet Switch CLI Reference Guide
DESCRIPTION
Adds a new vendor ID-based VLAN entry.
: 1-32 alphanumeric characters
name
: type the mask (from ff:ff:ff:00:00:00 to ff:ff:ff:ff:ff:ff) for
mask
the specified MAC address to determine which bits a
packet's MAC address should match. Enter "f" for each bit
of the specified MAC address that the traffic's MAC
address should match. Enter "0" for the bit(s) of the
matched traffic's MAC address, which can be of any
hexadecimal character(s). For example, if you set the
MAC address to 00:13:49:00:00:00 and the mask to
ff:ff:ff:00:00:00, a packet with a MAC address of
00:13:49:12:34:56 matches this criteria.
: Enter a number between 0 and 255 to specify
weight
the rule's weight. This is to decide the priority in which the
rule is applied. The higher the number, the higher the rule's
priority.
Removes an existing vendor ID-based VLAN entry.
Show status of the vendor ID-based VLAN.
Mask VLAN
----------------- ----
ff:ff:ff:00:00:00
337
Priority Weight
-------- ------
222 3 200
M P
C 13
C 13
E 13