ZyXEL Communications XS3800-28 Cli Reference Manual page 82

This command shows traffic class.
switch# show traffic-class
Traffic Class Profile Configuration:
Traffic Class ID
----------------
Next, configure a port for traffic class(es) and bind priorities to traffic classes on a port. In the next
example, we configure port 1 and bind priorities 0, 1 and 2 to traffic class 2 (LAN), 3, 4, 5 and 6 to class 1
(SAN) and 7 to class 0, the default traffic class.
Table 59 ETS Example Priority Traffic Class ID Mapping
PRIORITY
sysname(config)# interface port-channel 1
sysname(config-interface)# ets
sysname(config-interface)# ets traffic-class binding 2 2 2 1 1 1 1 0
sysname(config-interface)# unicast-nonunicast-weight 100 100
sysname(config-interface)# exit
20.2.5 Application Priority
Use the application priority command to assign a priority to all FCoE traffic on a switch.
The following table lists the commands for this feature.
Table 60 application priority Command Summary
COMMAND
lldp dcbx application <ether-
type><fcoe> priority <0-7>
no lldp dcbx application <ether-
type > <fcoe>
Chapter 20 Data Center Bridging Commands
Scheduler
---------
0 sp
1 ets
2 ets
TRAFFIC CLASS ID
0
1
2
3
4
5
6
7
Ethernet Switch CLI Reference Guide
Weight Name
------ -------------------------------
- Default
50 LAN
50 SAN
2
2
2
1
1
1
1
0
DESCRIPTION
Assigns the specified priority value to all FCoE traffic
on the Switch.
Clears priority value for all FCoE traffic on the Switch.
82
NAME
LAN
LAN
LAN
SAN
SAN
SAN
SAN
Default
M P
C 13
C 13