ZyXEL Communications XS3800-28 Cli Reference Manual page 22

sysname# reload config 1
Do you really want to reboot system with configuration file 1? [y/N]y
Bootbase Version: V1.05 | 12/19/2013 16:57:54
DRAM calibration...PASSED
RAM: Size = 131072 Kbytes
ZyNOS Version: V4.50(AAHW.0)b3_20171020_1 | 10/20/2017 16:9:36
Press any key to enter debug mode within 1 second.
....................
(Compressed)
Version: GS2210, start: b4962430
Length: 16F0668, Checksum: 03AA
Compressed Length: 2EE424, Checksum: 87A5
Copyright (c) 1994 - 2017 Zyxel Communications Corp.
initialize mgmt, initialize switch, ethernet address: 00:19:cb:00:00:01
Initializing MSTP.............
Initializing VLAN Database...
Initializing IP Interface...
Initializing Advanced Applications...
Initializing Command Line Interface...
Initializing Web Interface...
Restore System Configuration...
Start Auto Configuration...
..............
Try to download and restore configuration file from TFTP://10.90.90.11/
TestConf2
Downloading....
Get the file TestConf2, length 289 bytes.
Restoring......
Auto-config processes successfully.
Press ENTER to continue...
Use this command to check whether the auto configuration file was loaded successfully.
9
Show auto-config
Mode: DHCP
State: Success
Filename: TFTP://10.90.90.11/TestConf2
3.7 Using Custom Default
Follow the steps below to set up configurations on the Switch, so you can load a customized default file
when you reboot the Switch.
Use this command to enable custom default on the Switch.
1
custom-default
sysname# config
sysname(config)# custom-default
Chapter 3 Initial Setup
Ethernet Switch CLI Reference Guide
22