ZyXEL Communications XS3800-28 Cli Reference Manual page 136

Table 96 interface Command Summary (continued)
COMMAND
media-type 10g <SFP+|DAC10G>
name <port-name-string>
no flow-control
no inactive
no intrusion-lock
pvid <1-4094>
qos priority <0-7>
speed-duplex <auto|10-half|10-
full|100-half|100-full|1000-
full|1000-auto|10000-
full|40000-full>
no interface <port-num>
show interfaces <port-list>
show interfaces <port-list> | begin
<string>
show interfaces <port-list> | begin
<string1> include <string2>
show interfaces <port-list> |
include <string>
show interfaces <port-list> |
refresh
show interfaces config <port-list>
show interfaces utilization
show interfaces utilization | begin
<string>
Chapter 37 Interface Commands
DESCRIPTION
Sets the media type of the SFP+ module that is
attached to the 10 Gigabit interface.
On the Switch that has a 10 Gigabit interface, such as
the SFP+ slot, you can insert either an SFP+ transceiver
or an SFP+ Direct Attach Copper (DAC). An SFP+
Direct Attach Copper (DAC) is an SFP+ housing that
has no optical module but uses a fixed-length passive
copper cable assembly, which reduces cost and
power significantly.
Sets a name for the port(s).
port-name-string: up to 64 English keyboard
characters
Disables flow control on the port(s).
Enables the port(s) on the Switch.
Disables intrusion-lock on a port so that a port can be
connected again after you disconnected the cable.
The default PVID is VLAN 1 for all ports. Sets a PVID in
the range 1 to 4094 for the specified interface.
Sets the quality of service priority for an interface.
Sets the duplex mode (
( ,
10 100
connection on the interface. Select
negotiation) to let the specified port(s) negotiate with
a peer to obtain the connection speed and duplex
mode.
Resets the port counters for the specified port(s).
Displays the current interface status for the specified
port(s).
Displays the current interface status and statistics for
the specified port(s), which start from a line with the
specified string.
Displays the current interface status and statistics for
the specified port(s), which start from a line with the
first specified string and also contain the second
specified string.
Displays the current interface status and statistics for
the specified port(s), which contain the specified
string.
Displays the current interface status and statistics for
the specified port(s), and updates every second until
you press the [ESC] button.
Displays current interface configuration for the
specified port(s).
Displays the percentage of actual transmitted and
received frames on a port as a percentage of the link
speed.
Displays the link speed and percentage of actual
transmitted and received frames on a port, which
start from a line with the specified string.
Ethernet Switch CLI Reference Guide
136
or
half full
, , or
1000 10000 40000
auto
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
) and speed C 13
Mbps) of the
(auto-
E 13
E 3
E 3
E 3
E 3
E 3
E 3
E 3
E 3