ZyXEL Communications XS3800-28 Cli Reference Manual page 5

• <cr> means press the [ENTER] key.
• An arrow (-->) indicates that this line is a continuation of the previous line.
Command summary tables are organized as follows:
Table 1 Example: Command Summary Table
COMMAND
show vlan
vlan <1-4094>
inactive
no inactive
no vlan <1-4094>
The Table title identifies commands or the specific feature that the commands configure.
The COMMAND column shows the syntax of the command.
• If a command is not indented, you run it in the enable or config mode. See
more information on command modes.
• If a command is indented, you run it in a sub-command mode.
The DESCRIPTION column explains what the command does. It also identifies legal input values, if
necessary.
The M column identifies the mode in which you run the command.
• E: The command is available in enable mode. It is also available in user mode if the privilege level (P)
is less than 13.
• C: The command is available in config (not indented) or one of the sub-command modes (indented).
The P column identifies the privilege level of the command. If you don't have a high enough privilege
level you may not be able to view or execute some of the commands. See
more information on privilege levels.
Document Conventions
DESCRIPTION
Displays the status of all VLANs.
Enters config-vlan mode for the specified VLAN. Creates
the VLAN, if necessary.
Disables the specified VLAN.
Enables the specified VLAN.
Deletes a VLAN.
Ethernet Switch CLI Reference Guide
5
M P
E 3
C 13
C 13
C 13
C 13
Chapter 2 on page 13
Chapter 2 on page 13 for
for