ZyXEL Communications XS3800-28 Cli Reference Manual page 289

Table 182 running-config Command Summary (continued)
COMMAND
reload custom-default
reload factory-default
sync running-config
76.3 Command Examples
This example resets the Switch to the factory default settings.
sysname# erase running-config
sysname# write memory
This example copies all attributes of port 1 to port 2 and copies selected attributes (active, bandwidth
limit and STP settings) from port 1 to ports 5-8
sysname# configure
sysname(config)# copy running-config interface port-channel 1 2
sysname(config)# copy running-config interface port-channel 1 5-8 active
bandwidth-limit spanning-tree
Chapter 76 Running Configuration Commands
DESCRIPTION
Reboots the system and loads a saved customized default
file on the Switch.
Note: This will save the customized default
Note: If you did not save a customized default file in
Note: For the GS2210 Series, you need to enable
Note: For the GS2210 Series, if you had saved a
Resets the Switch to the factory default settings, including
default user name and password.
Uses the current configuration on the active management
card to update the current configuration on the standby
management card.
Ethernet Switch CLI Reference Guide
289
configuration settings to both Configuration 1
and Configuration 2.
the web configurator or CLI using copy
running-config custom-default, then the
factory default file is restored. You will then
have to make all your configurations again on
the Switch.
custom default in the web configurator or CLI
using custom-default first.
Config 2 file in the web configurator or CLI
using write memory [<index>], but didn't
save a customized default file, then the
Config 2 file is restored.
M P
E 14
E 14
E 13