ZyXEL Communications XS3800-28 Cli Reference Manual page 195

48.2 Command Examples
This example enables loopguard on ports 1-3.
sysname# configure
sysname(config)# loopguard
sysname(config)# interface port-channel 1-3
sysname(config-interface)# loopguard
sysname(config-interface)# exit
sysname(config)# exit
sysname# show loopguard
LoopGuard Status: Enable
Port Port
No Status
---- --------
1 Active
2 Active
3 Active
4 Active
--------------------------------- SNIP ---------------------------------
The following table describes the labels in this screen.
Table 136 show loopguard
LABEL
LoopGuard Status
Port No
Port Status
LoopGuard Status
Total TxPkts
Total RxPkts
Bad Pkts
Shutdown Time
Chapter 48 Loopguard Commands
LoopGuard Total
Status TxPkts
--------- --------
Enable 0
Enable 0
Enable 0
Disable 0
DESCRIPTION
This field displays whether or not loopguard is enabled on the Switch.
This field displays the port number.
This field displays whether or not the port is active.
This field displays whether or not loopguard is enabled on the port.
This field displays the number of packets that have been sent on this port since
loopguard was enabled on the port.
This field displays the number of packets that have been received on this port since
loopguard was enabled on the port.
This field displays the number of invalid probe packets that were received on this port.
This field displays the last time the port was shut down because a loop state was
detected.
Ethernet Switch CLI Reference Guide
195
Total Bad Shutdown
RxPkts Pkts Time
-------- ---- ------------------
0 0 00:00:00 UTC Jan 1 1970
0 0 00:00:00 UTC Jan 1 1970
0 0 00:00:00 UTC Jan 1 1970
0 0 00:00:00 UTC Jan 1 1970