ZyXEL Communications XS3800-28 Cli Reference Manual page 97

25.3 Command Examples
In this example, the Switch is configured to exchange DVMRP information with other DVMRP enabled
routers as shown next. The Switch is a DVMRP router (C). DVMRP is activated on IP routing domains
10.10.10.1/24 and 172.16.1.1/24 so that it can exchange DVMRP information with routers A and B.
Figure 7 DVMRP Network Example
10.10.10.254
• Enables IGMP and DVMRP on the Switch.
• Enables DVMRP on the following routing domains: 10.10.10.1/24, 172.16.1.1/24.
• Displays DVMRP settings configured on the Switch.
sysname(config)# router igmp
sysname(config-igmp)# exit
sysname(config)# router dvmrp
sysname(config-dvmrp)# exit
sysname(config)# interface route-domain 10.10.10.1/24
sysname(config-if)# ip dvmrp
sysname(config-if)# exit
sysname(config)# interface route-domain 172.16.1.1/24
sysname(config-if)# ip dvmrp
sysname(config-if)# exit
sysname(config)# exit
sysname# show router dvmrp
TTL threshold: 50
IP Address
----------------------------------------
10.10.10.1
172.16.1.1
192.168.1.1
Chapter 25 DVMRP Commands
B
A
172.16.1.254
C
D
Subnet Mask Active
255.255.255.0 Yes
255.255.255.0 Yes
255.255.255.0 No
Ethernet Switch CLI Reference Guide
E
97